supply of equipment : callender and barnes equipment for determining j by constant flow method and should be equipped with colorimeter with constant level tank [ inco], measuring board containing precise voltmeters (2 nos 4&1/2 digit), low resistance with reg. power supply 0 12 v/3 a, digital stop clock[0.01 sec] ,digital thermometers [0.1deg] (2nos), measuring cylinder etc., study of variation of thermo-emf of thermocouple with difference of temperature of its junction from direct measurement
using operational amplifier and to determine neutral temperature., complete unit containing 2 sets of thermocouples (reference & experimental), op-amp circuit, digital meter (4&1/2 digit) regulated oven (temp range: up to 500 deg c. ,operational amplifier of gain 10, etc., diffraction grating : 100 lines/mm, transmission type imported replica on glass plate and covered with another glass plate brand: h&w, diffraction grating : 300 line/mm, transmission type imported replica on glass plate and covered with another glass plate brand: h&w, measurement set up of magnetoresistance for semiconductors (mrx-01) without magnet, magnet power supply and gauss meter:, the set-up consists of following units:, (i) four probe arrangement, fpa-mrx-02, (ii) sample: ge crystal (n-type), dmr-sn, (iii) hall probe multipurpose stand, hps, (iv) magnetoresistance setup, dmr-02, prism (edf) r .i 1.65 (32 x 32 mm), spectrometer, model : v.c : 20 sec, scale :178 mm, circular slit, expt. on self inductance by anderson bridge.-a complete set with decade type, p.o. box. resistance box (2 nos),ac/dc source and null detector, decade type capacitor box,2 nos ferrite core inductors, function generator : js-803a - 3 mhz dds signal generator[0-20v (p-p)], sine, square, triangle, pulse,(triangle to 300 khz),with voltage & frequency readout also., ac millivoltmeter : true rms a.c. millivoltmeter, model acm-102 (range:0- 20mv, 0-200mv, 0-2v & 0-20v), ballistic galvanometer, d type ,sett & de t.p 16 sec, cdr 2 k, regulated power supply (0-5v/1a) with coarse & fine adjustment, with digital meter, control unit of four probe setup, dfp-rm-200n, ge sample for four probe, magnet power supply for hall effect : constant current power supply, dps- 50, regulated power supply, (without meter) model ps-12 (+/-12v & +/- 5v)/0.3a, regulated power supply, make: rel (0-15v/1a) (variable) coarse & fine adjustment (with digital meter), regulated power supply (0-2v/1a) with coarse & fine adjustment,, digital lcr meter with hz measurement, frequency metravi,451-digital lcr multimeter3-1/2 digit, digital ammeter 0-200 ma d.c 3&1/2 digit, fitted on base, digital voltmeter 0-2/20/200v d.c, 3& digit fitted on base, digital voltmeter 0-200mv d.c, 3&1/2 digit, fitted on base, dso-5050 digital storage oscilloscope 50 mhz with colour display, 0.5 gsa/sec sampling rate, with usb pc interface cable and software, with usb device. with 1:1&1:10 probe pair,, ujt [electronic component], red laser with power supply, green laser with power supply, digital thermometer, multi stem thermometer[ms-408], electronic components (ic chip- 74 series, op amp, 555, resistor, capacitor, inductor) per set, travelling microscope, tvm-02, (2-way motion).
Tender247 tries to ensure accurate & authentic tender information at its level best however it cannot be held responsible for Omissions, Errors, etc. Users are advised to refer to Tender Document published by Procuring entity before participating / submitting bid.
LOADING...
